Armored thermal resistance of the installation and use

Armored thermal resistance of the installation and use thermal resistance should prevent devices beside the stove too close to or from the heating body, should be installed as far as possible without vibration or the location of the vibration is very small, to facilitate the construction and maintenance. Device status should be able to adhere to the vertical, but in a flow velocity are necessary tilting device. Junction box out of the hole should be down.

by thermal inertia make the thermal resistance lag temperature changes, to eliminate the error of its cause, to do maintenance can effectively reduce the thermal resistance pipe diameter, the appropriate growth of thermal resistance draw depth make thermal resistance heat position increase.

thermal resistance should be according to the rules of the wiring, ordinary USES three wire system. Connecting wires should be insulated ( Screen is open) Copper wire, the cross-sectional area shall be 1 or more. 0 square millimeter, the resistance of the wire shall be according to the rules of the display instrument.

verify the maintenance of thermal resistance, often found oxidation or deformation shall immediately take measures to check should be conducted current.