Infrared thermometers use method and matters needing attention

Infrared thermometer method of use: 1, whose first gun goes to zero. 2, the ear temperature gun on baby's ear and do in-depth. 3, press the measure button, when the ring after confirmation note, ear temperature gun can only left ear. Infrared thermometer note: 1, often in the ear and ear, the measured temperature will be slightly different between the two ear temperature difference may be 0 centigrade. 5 degrees, give priority to with the temperature of heat. 2, if the two ears on the edge of the temperature difference is too large, or critical temperature fever, measured again in half an hour at a time. 3 in air conditioning room or outdoors in the winter and summer for a long time, the temperature may be lower, must pay special attention to. 4, the participants should be at least 20 minutes at room temperature, let the body temperature balance. 5, before use to avoid ear moisture and keep your ear clean. Ear without obstruction and excessive earwax accumulation in order to measure temperature accurately. 6, after strenuous exercise, should rest for at least 30 minutes before measurement. 7, please don't ear temperature measurement when waking up, because the pin the side ear temperature will be higher than normal body temperature. 8, usually between the ear and the ear the measured temperature will be slightly different, so in the same ear to measure body temperature. 9, when continuous repeated measurement, please will probe head move between each measure, and intermittent rest for at least 5 seconds before the next measurement, so the correct measurement results can be obtained. 10, about 35 normal measurement reading values. 5℃～37. 8 ℃, the user should be measured temperature more at ordinary times, in order to understand their health temperature, if there is any abnormal body changes or ask your doctor should be paid attention to. 11, after each measurement need alcohol to clean the infrared ear thermometer probe letter head, to avoid wax jams affect the measurement result, to ensure the accuracy of measurement when next time.