Sanitary stainless steel bimetallic thermometer thermometer factory group installation instructions

Thermometer factory group, the installation of sanitary stainless steel bimetallic thermometer should be paid attention to for accurate temperature measurement, safety examination and maintenance is convenient, and does not affect the equipment operation and production operations, to meet the above requirements, in the choice of thermal resistance of the installation site and insertion depth to pay attention to the following points: ( 1) In order to make the measurement of thermal resistance end and have good heat exchange between the measured medium, should be a reasonable choice of observation, try to avoid the valve, elbow and pipe and equipment near the corner of installing heat resistance. （ 2) With a protective casing thermal resistance of heat transfer and heat loss, in order to reduce the measurement error, thermocouple and thermal resistance should have enough insert depth: a, for heat resistance temperature center fluid, usually should be measuring end is inserted into the pipe center ( Vertical or inclined installation) 。 As the current body of pipe diameter is 200 mm, the thermal resistance should choose insert depth 100 mm; B, for high temperature and high pressure and high velocity of temperature measurement, Such as main steam temperature) , in order to reduce cases of fluid resistance and prevent cases break under the action of a fluid, can take protecting tube shallow inserted way or use hot shell heat resistance. Shallow inserted type thermal resistance to protect casing, and its depth into the steam pipe should be no less than 75 mm; On a hot resistance standard insert depth of 100 mm; C, if is need to measure the temperature of flue gas, although the flue is 4 m in diameter, the heat resistance of insertion depth of 1 m; D, when measuring the original insertion depth of more than 1 m, shall be installed vertically, as far as possible or add racks and protect casing.